Native firmware¶

Here is the native firmware for AD5M, AD5MPro, AD5X printers

How to install native firmware¶

Reset the printer to default settings.
Format a USB drive to FAT/FAT16/FAT32.
Copy the appropriate file to the USB root directory
Power off the printer.
Insert the usb drive into printer usb port.
Power on the printer.

AD5X native firmware¶

AD5M native firmware¶

AD5MPro native firmware¶

Installing full firmware on AD5X¶

Installation takes a long time, up to an hour.

Download to flash drive

AD5X-factory-1.0.9.tgz
AD5X-factory.tar.xz
After the update, if you need to reflash the MCU, install AD5X

Installing full firmware on FF5M¶

Installation takes a long time, up to an hour.

Download to flash drive

Adventurer5M-factory-3.1.3.tgz
Adventurer5M-factory.tar.xz
config.tar, if you previously did it via TAR_CONFIG
After the update, if you need to reflash the MCU, install Adventurer5M-3.1.9-2.2.3-20250807-Factory.tgz

AD5X-ENABLE-zmod.tgz¶

Enabling zmod on AD5X after updating the native firmware allows you to activate the mod without completely reinstalling it

AD5X-ENABLE-zmod.tgz

SET XY¶

For those who've lost their minds and moved their "home" (parking lot to the poop bin). Extract the archive contents to the root of a flash drive, insert the flash drive, and reboot the printer. The calibration will load. First, press Reset. Then, use the on-screen control buttons to adjust the correct head position. Press the Set button to lock this. Reboot the printer without the flash drive. Archive from official Flashforge support.

Set.XY.Offset.zip